On the gambrel roof - I cut several boards to make the trusses but in different batches. While the over all length is the same and they fit in the jig, the top touches and the bottom has a slight gap.
My dad used the chop saw at one point and it would seem the "22.5" mark is not as solid as I thought so when I reset the saw, it wasn't in the exact same angle, slightly off.
Is that ok? Do I have to re-cut it all?
*
My dad used the chop saw at one point and it would seem the "22.5" mark is not as solid as I thought so when I reset the saw, it wasn't in the exact same angle, slightly off.
Is that ok? Do I have to re-cut it all?
*